TM 9-6150-226-13
5-2.
COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equipment refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
5-3.
SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT.
Refer to Appendix B,
Maintenance Allocation Chart (MAC); TM 9-6150-226-
23P, Repair Parts and Special Tools List;
and paragraph 5-9c for a list of
special tools, TMDE, and support equipment for direct support maintenance.
5-4. REPAIR PARTS.
Repair Parts are listed and illustrated in TM 9-6150-226-23P for DISE and
PDISE equipment.
Section II.
DIRECT SUPPORT TROUBLESHOOTING
Subject
Scope Troubleshooting
Troubleshooting
Section Index
Page
5-2
5-2
5-5.
SCOPE TROUBLESHOOTING.
This section contains troubleshooting information and tests for locating
and correcting malfunctions in the DISE/PDISE equipment.
F a u l t i s o l a t i o n i s
limited to those components authorized for repair or replacement at the direct
support or lower maintenance levels in accordance with the MAC, and will refer
the maintenance technician to the technical manual for generator set faults.
5-6. TROUBLESHOOTING.
The troubleshooting table lists the common malfunctions which you may
find during the operation or maintenance of DISE/PDISE or its components.
You
should perform the tests/inspections
a n d c o r r e c t i v e a c t i o n s i n t h e o r d er
l i s t e d.
b.
The manual cannot list all malfunctions that may occur, nor all tests
or inspections and corrective actions.
If a malfunction is not listed or is
not corrected by listed actions, notify your supervisor.
c.
Troubleshooting
Instructions.
Direct support troubleshooting lists
the common malfunctions which can occur during the operation of the DISE and
PDISE equipment.
Each malfunction
is
followed
by
a
list
of
tests
or
inspections which will help to determine corrective actions to take.
5-2
