TM 9-6115-730-24
0116
REMOVAL
1. Remove six bolts (Figure 1, Item 1), washers (Figure 1, Item 2), bolts (Figure 1, Item 3), washers (Figure 1,
Item 4), inlet manifold (Figure 1, Item 5) and three gaskets (Figure 1, Item 6).
2. If necessary, remove plug (Figure 1, Item 7), plug (Figure 1, Item 8), seal (Figure 1, Item 9), and plug
(Figure 1, Item 10).
3. If necessary, remove four screws (Figure 1, Item 11), washers (Figure 1, Item 12), elbow (Figure 1, Item 13),
and gasket (Figure 1, Item 14).
4. If necessary, remove plug (Figure 1, Item 15).
END OF TASK
INSTALLATION
1. If necessary, install plug (Figure 1, Item 15).
2. If necessary, install elbow (Figure 1, Item 13) and gasket (Figure 1, Item 14) with four screws (Figure 1,
Item 11) and washers (Figure 1, Item 12).
3. If necessary, install plug (Figure 1, Item 10), seal (Figure 1, Item 9), plug (Figure 1, Item 8), and plug
(Figure 1, Item 7).
4. Install three gaskets (Figure 1, Item 6), inlet manifold (Figure 1, Item 5), six washers (Figure 1, Item 4), bolts
(Figure 1, Item 3), washers (Figure 1, Item 2), and bolts (Figure 1, Item 1). Torque bolts (Figure 1, Item 3) and
(Figure 1, Item 1) to 34-48 lb-ft (45-65 Nm).
5. Install intake manifold air temperature sensor and turbo outlet pressure sensor (WP 0098).
0116-2
