TM 9-6115-730-24
0117
REMOVAL
1. Remove 14 bolts (Figure 1, Item 1), washers (Figure 1, Item 2), isolators (Figure 1, Item 3), and sleeves
(Figure 1, Item 4), and remove oil pan (Figure 1, Item 5) and gasket (Figure 1, Item 6).
2. Remove drain valve (Figure 1, Item 7), pipe reducer (Figure 1, Item 8), bushing (Figure 1, Item 9), recessed
washer (Figure 1, Item 10), and seal (Figure 1, Item 11), plug (Figure 1, Item 12), magnetic plug (Figure 1,
Item 13), and seal (Figure 1, Item 14).
3. If necessary, scrape gasket material (Figure 1, Item 6) off engine block and oil pan.
4. Inspect magnetic plug (Figure 1, Item 13) for metal particles and wipe clean. Notify supervisor if metal
particles are found on magnetic plug.
END OF TASK
INSTALLATION
1. Install seal (Figure 1, Item 14), magnetic plug (Figure 1, Item 13), plug (Figure 1, Item 12), seal (Figure 1,
Item 11), recessed washer (Figure 1, Item 10), bushing (Figure 1, Item 9), pipe reducer (Figure 1, Item 8), and
drain valve (Figure 1, Item 7).
2. Install gasket (Figure 1, Item 6), oil pan (Figure 1, Item 5), 14 sleeves (Figure 1, Item 4), isolators (Figure 1,
Item 3), washers (Figure 1, Item 2), and bolts (Figure 1, Item 1).
3. Refill lubrication system (WP 0079).
0117-2
