TM 9-6115-730-24
0091
INSTALLATION - Continued
2. Install heater exhaust adapter (Figure 1, Item 25) on skid base and secure with four washers (Figure 1, Item
28), lockwashers (Figure 1, Item 27), and screws (Figure 1, Item 26).
3. Connect flexible exhaust tubing (Figure 1, Item 24) to heater exhaust adapter (Figure 1, Item 25) and to
heater (Figure 1, Item 6) and install hose clamp (Figure 1, Item 23).
4. Connect flexible braided leak-off hose (Figure 1, Item 22) to OUT side of fuel metering pump (Figure 1, Item
18) and to bottom of heater (Figure 1, Item 6) and install two hose clamps (Figure 1, Item 21).
5. Connect low-pressure hose (Figure 1, Item 17) to male hose barb fitting (Figure 1, Item 20) on left side of fuel
tank and install hose clamp (Figure 1, Item 19).
6. Connect low-pressure hose (Figure 1, Item 17) to IN side of fuel metering pump (Figure 1, Item 18) and install
hose clamp (Figure 1, Item 16).
7. Install clamp (Figure 1, Item 15), lockwasher (Figure 1, Item 14), and screw (Figure 1, Item 13) on hose
(Figure 1, Item 17).
8. Connect hose (Figure 1, Item 10) to bottom of heater (Figure 1, Item 6) and install hose clamp (Figure 1,
Item 12).
9. Connect hose (Figure 1, Item 10) to shutoff valve (Figure 1, Item 11) located below alternator and install hose
clamp (Figure 1, Item 9).
10. Install 90-degree hose elbow (Figure 1, Item 8) and hose mender fitting (Figure 1, Item 5) on heater (Figure 1,
Item 6) and install two hose clamps (Figure 1, Item 7).
11. Connect hose (Figure 1, Item 2) to hose mender fitting (Figure 1, Item 5) and install hose clamp (Figure 1,
Item 4).
12. Connect hose (Figure 1, Item 2) to shutoff valve (Figure 1, Item 3) located behind alternator and install hose
clamp (Figure 1, Item 1).
13. Refill cooling system (see WP 0064).
14. Close left front door, battery access doors, and right front doors.
END OF TASK
END OF WORK PACKAGE
0091-4
