TM 9-6115-730-24
UNIT (FIELD) LEVEL MAINTENANCE
TACTICAL QUIET GENERATOR 200 kW, 50/60 Hz MEP-809A/PU-809A
INSTALLATION OF GENERATOR SET ON TRAILER
INITIAL SETUP:
Tools and Special Tools
Personnel Required
Lifting Device, 10,000 lb (4535 kg) capacity
Two
Shop Equipment, Automotive Maintenance,
Common No. 1 (WP 0123, Item 2)
References
Tool Kit, General Mechanic's (WP 0123, Item 1)
TM 9-2330-376-14&P
TM 9-6115-730-24P
WARNING
The 200 Kw TQG weighs approximately 9300 lb (4218 kg) and requires an assistant and a lifting
device (forklift, overhead lifting device) with sufficient capacity. Failure to comply can cause
serious injury or death to personnel.
Be extremely careful when working near the 200 kW TQG as it is being positioned on the trailer.
Failure to comply can cause injury to personnel.
INSTALLATION
1. Park XM1051 E1 trailer (Figure 1, Item 1) on level hard surface. Lower support legs (see TM 9-2330-376-
14&P). Level trailer and chock wheels.
2. Using lifting device with sufficient capacity, maneuver TQG (Figure 1, Item 2), with control panel end toward
tongue of trailer, into position over mounting holes on bed of trailer (Figure 1, Item 1).
3. Slowly lower TQG (Figure 1, Item 2) onto trailer (Figure 1, Item 1) and align with eight mounting holes.
4. Remove lifting device.
NOTE
All TQG-mounting screws are installed with nuts on top of bed of trailer, except at location A, at
right rear of trailer.
5. Install eight screws (Figure 1, Item 3), 16 washers (Figure 1, Item 4), and eight nuts (Figure 1, Item 5). Torque
eight nuts (Figure 1, Item 5) to 125 lb-ft (170 Nm).
0084-1
