TM 9-6115-730-24
0078
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch
is OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open left rear doors.
3. Remove bolt (Figure 1, Item 1), washer (Figure 1, Item 2), bolt (Figure 1, Item 3), washer (Figure 1, Item 4),
fuel priming pump (Figure 1, Item 5), and gasket (Figure 1, Item 6).
END OF TASK
INSTALLATION
1. Clean area where gasket (Figure 1, Item 6) will mate with engine.
2. Apply a light coat of fuel to gasket and install gasket (Figure 1, Item 6), fuel priming pump (Figure 1, Item 5),
washers (Figure 1, Item 4), bolt (Figure 1, Item 3), washer (Figure 1, Item 2), and bolt (Figure 1, Item 1).
Tighten bolts.
3. Close left rear doors.
0078-2
