TM 9-6115-730-24
0072
INSTALLATION
1. Install two hose fittings (Figure 1, Sheet 1, Item 30) to crankcase ventilation filter (Figure 1, Sheet 2, Item 32).
2. Install two air cleaner mounting bands (Figure 1, Sheet 1, Item 26) and secure with four screws (Figure 1,
Sheet 1, Item 31), washers (Figure 1, Sheet 1, Item 30), and locknuts (Figure 1, Sheet 1, Item 29).
WARNING
Air cleaner weighs 66 pounds (30 kg) and requires a two-person lift. Ensure proper lifting
techniques are used when lifting air cleaner. Failure to comply can cause injury to personnel.
3. Install air cleaner (Figure 1, Sheet 1, Item 2) in two air cleaner mounting bands (Figure 1, Sheet 1, Item 26)
and tighten two nuts (Figure 1, Sheet 1, Item 25).
4. Install air cleaner cover (Figure 1, Sheet 1, Item 27) and tighten wing nut (Figure 1, Sheet 1, Item 28).
5. Install crankcase ventilation filter (Figure 1, Sheet 2, Item 10) on bracket (Figure 1, Sheet 2, Item 24) and
secure with two screws (Figure 1, Sheet 2, Item 21), lockwashers (Figure 1, Sheet 2, Item 22), and washers
(Figure 1, Sheet 2, Item 23).
6. Install elbow (Figure 1, Sheet 2, Item 20) and check valve (Figure 1, Sheet 2, Item 19) in left hand rear engine
dipstick port.
7. Connect hose (Figure 1, Sheet 2, Item 17) from swivel fitting (Figure 1, Sheet 2, Item 18) on bottom of
crankcase ventilation filter (Figure 1, Sheet 2, Item 10) and to check valve (Figure 1, Sheet 2, Item 19) on left
hand rear engine dipstick port, and install two clamps (Figure 1, Sheet 2, Item 16).
8. Connect hose (Figure 1, Sheet 2, Item 15) to IN port fitting on crankcase ventilation filter (Figure 1, Sheet 2,
Item 10) and to engine crankcase filter adapter, and install two clamps (Figure 1, Sheet 2, Item 14).
9. Connect air vent hose (Figure 1, Sheet 1, Item 12) to engine turbo and install clamp (Figure 1, Sheet 1,
Item 13).
10. Connect restricted tap sleeve (Figure 1, Sheet 1, Item 6) to air vent hose (Figure 1, Sheet 1, Item 12) and
install clamp (Figure 1, Sheet 1, Item 11).
11. Connect hose (Figure 1, Sheet 1, Item 9) to restricted tap sleeve (Figure 1, Sheet 1, Item 6) and to OUT port
fitting on crankcase ventilation filter (Figure 1, Sheet 2, Item 10), and install two clamps (Figure 1, Sheet 1,
Item 8).
12. Install sensor (Figure 1, Sheet 1, Item 7) on restricted tap sleeve (Figure 1, Sheet 1, Item 6).
13. Install reducing elbow (Figure 1, Sheet 1, Item 5) on air cleaner (Figure 1, Sheet 1, Item 2) and restricted tap
sleeve (Figure 1, Sheet 1, Item 6) and install two clamps (Figure 1, Sheet 1, Item 4) and (Figure 1, Sheet 1,
Item 3).
14. Install air cleaner indicator (Figure 1, Sheet 1, Item 1) on air cleaner (Figure 1, Sheet 1, Item 2).
15. Close left front door and right front doors.
END OF TASK
END OF WORK PACKAGE
0072-5/6 blank
