TM 9-6115-730-24
0066
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open right front doors and left front door.
NOTE
Table 1 lists removal and installation steps for fan and fan guard elements.
Table 1. WP 0066 Guide.
FIGURE 1
REMOVAL
INSTALLATION
NAME
ITEM
STEPS
STEPS
Upper right fan guard
4
3 thru 6
19 thru 23
5 and 7 thru 9
17 thru 21
Lower right fan guard
12
10 thru 12
14 and 15
Upper left fan guard
36
Lower left fan guard
37
13 and 14
12, 13 thru 15
20 thru 22 and 24
2, 4 thru 6
Left shroud flange
41
Right shroud flange
16
20 thru 23
3 thru 6
Fan and adapter
86, 87
3 thru 25
1 and 2
3. Remove nut (Figure 1, Sheet 1, Item 1), lockwasher (Figure 1, Sheet 1, Item 2), and screw (Figure 1, Sheet 1,
Item 3) attaching rear of upper right fan guard (Figure 1, Sheet 1, Item 4) to top of engine.
4. If necessary, remove nut (Figure 1, Sheet 1, Item 5), washer (Figure 1, Sheet 1, Item 6), lockwasher (Figure 1,
Sheet 1, Item 7), and bracket (Figure 1, Sheet 1, Item 8).
5. Remove two locknuts (Figure 1, Sheet 1, Item 9), washers (Figure 1, Sheet 1, Item 10), and screws (Figure 1,
Sheet 1, Item 11) attaching upper right fan guard (Figure 1, Sheet 1, Item 4) and lower right fan guard
(Figure 1, Sheet 1, Item 12) together.
6. Remove four screws (Figure 1, Sheet 1, Item 13), washers (Figure 1, Sheet 1, Item 14), lockwashers (Figure 1,
Sheet 1, Item 15), and upper right fan guard (Figure 1, Sheet 1, Item 4) from right shroud flange (Figure 1,
Sheet 1, Item 16).
7. Remove locknut (Figure 1, Sheet 1, Item 17), washer (Figure 1, Sheet 1, Item 18), and screw (Figure 1,
Sheet 1, Item 19) attaching rear of lower right fan guard (Figure 1, Sheet 1, Item 12) to bracket (Figure 1
Sheet 1, Item 20) attached to engine.
