TM 9-6115-730-24
0062
REMOVAL - Continued
CAUTION
Note orientation of sender assembly to ensure correct installation.
4. Remove five screws (Figure 1, Sheet 1, Item 2), lockwashers (Figure 1, Sheet 1, Item 3), washers (Figure 1,
Sheet 1, Item 4), fuel level sender assembly (Figure 1, Sheet 1, Item 1), and gasket (Figure 1, Sheet 1,
Item 5).
END OF TASK
TEST AND INSPECTION
1. Remove five screws, lockwashers and fuel level sender assembly from fuel tank.
2. Set Battery Disconnect Switch to ON.
3. Set DEAD CRANK SWITCH to NORMAL.
4. Set Engine Control Switch to COOL DOWN/STOP.
5. Hold fuel level sender (Figure 1, Sheet 1, Item 1) in vertical position with armature (Figure 1, Sheet 2, Item 6)
hanging down. Fuel level indicator should read "E" +/- 1/8 inch.
6. Raise armature (Figure 1, Sheet 2, Item 6) to full up position. Fuel level indicator should read "F" +/- 1/8 inch.
7. Check resistance in "Full" and "Empty" positions according to Figure 1, Sheet 2.
8. If resistance measurements are incorrect, replace fuel level sender.
9. If resistance measurements are correct, verify the wiring per FO-1, Sheet 2 and FO-3, Sheet 1.
10. If the wiring is correct, replace fuel indicator.
END OF TASK
0062-4
