TM 9-6115-730-24
0061
DRAINING
1. Open left front door.
2. Rotate valve (Figure 1, Item 1) and air vent (Figure 1, Item 2) to allow water to drain from bowl (Figure 1,
Item 3).
3. Rotate valve (Figure 1, Item 1) and air vent (Figure 1, Item 2) to close.
4. Close left front door.
END OF TASK
WATER SEPARATOR FILTER ASSEMBLY REPLACEMENT
1. Open left front door.
2. Remove clamp (Figure 1, Item 4) and disconnect hose (Figure 1, Item 5) from drain port on bottom of water
separator filter bowl (Figure 1, Item 3).
3. Remove water separator filter assembly (Figure 1, Item 7)
4. Install new filter element (Figure 1, Item 8) into water separator assembly (Figure 1, Item 7). Install new water
separator filter assembly.
5. Connect hose (Figure 1, Item 5) to bottom of bowl (Figure 1, Item 3) and install clamp (Figure 1, Item 4).
6. Close left front doors.
END OF TASK
WATER SEPARATOR FILTER REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF, Battery Disconnect Switch is OFF,
and DEAD CRANK SWITCH is OFF before proceeding.
2. Open left front doors.
NOTE
Cut tiedown straps as required.
3. Remove clamp (Figure 1, Item 4) and disconnect hose (Figure 1, Item 5) from drain port on bottom of water
separator filter bowl (Figure 1, Item 3).
4. Disconnect hose (Figure 1, Item 9) and hose (Figure 1, Item 10) from water separator filter assembly
(Figure 1, Item 7).
0061-2
