TM 9-6115-730-24
0060
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open left rear door assemblies.
3. Open right rear door assemblies.
4. Remove twenty screws (Figure 1, Sheet 1, Item 1), lockwashers (Figure 1, Sheet 1, Item 2), washers (Figure
1, Sheet 1, Item 3), and horizontal upper front base baffles (Figure 1, Sheet 1, Item 4 and Item 5).
5. Remove twelve screws (Figure 1, Sheet 2, Item 6), lockwashers (Figure 1, Sheet 2, Item 7), washers
(Figure 1, Sheet 1, Item 8), and horizontal lower front base baffles (Figure 1, Sheet 2, Item 9 and Item 10).
NOTE
Fuel will drain from fuel hoses when hoses are disconnected. Keep hoses elevated to minimize
fuel drainage.
6. Disconnect fuel hoses (Figure 1, Sheet 2, Item 11 and Item 12), from fuel cooler (Figure 1, Sheet 2, Item 13)
7. Remove four screws (Figure 1, Sheet 2, Item 14), eight washers (Figure 1, Sheet 2, Item 15), and four
bushings (Figure 1, Sheet 2, Item 16).
8. Remove fuel cooler (Figure 1, Sheet 2, Item 13).
END OF TASK
INSTALLATION
1. Install fuel cooler (Figure 1, Sheet 2, Item 13) with four bushings (Figure 1, Sheet 2, Item 16), eight washers
(Figure 1, Sheet 2, Item 15), and four screws (Figure 1, Sheet 2, Item 14).
2. Connect fuel hoses (Figure 1, Sheet 2, Item 12 and Item 11) onto fuel cooler (Figure 1, Sheet 2, Item 13).
3. Install horizontal lower front base baffles (Figure 1, Sheet 2, Item 10 and Item 9) with twelve washers (Figure
1, Sheet 2, Item 8), lockwashers (Figure 1, Sheet 2, Item 7), and screws (Figure 1, Sheet 2, Item 6).
4. Install horizontal upper front base baffles (Figure 1, Sheet 1, Item 5 and Item 4) with twenty washers (Figure
1, Sheet 1, Item 3), lockwashers (Figure 1, Sheet 1, Item 2), and screws (Figure 1, Sheet 1, Item 1).
5. Close right rear door assemblies.
6. Close left rear door assemblies.
0060-2
