TM 9-6115-730-24
0059
SERVICING
NOTE
Servicing can be performed without removing auxiliary fuel pump.
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch
is OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open left front doors and left rear doors.
3. Remove three screws (Figure 1, Item 1), cover (Figure 1, Item 2), gasket (Figure 1, Item 3), and strainer
(Figure 1, Item 4) from auxiliary fuel pump (Figure 1, Item 5).
4. Clean strainer (Figure 1, Item 4) with clean fuel. Replace strainer if damaged.
5. Install strainer (Figure 1, Item 4), gasket (Figure 1, Item 3), cover (Figure 1, Item 2), and three screws
(Figure 1, Item 1).
END OF TASK
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open left front doors and left rear doors.
NOTE
Cut tiedown straps as required.
3. Disconnect hose (Figure 1, Item 6) and hose (Figure 1, Item 7) from auxiliary fuel pump (Figure 1, Item 5).
4. Tag and disconnect wires coming from solenoid valve (Figure 1, Item 8).
5. Remove two locknuts (Figure 1, Item 9), washers (Figure 1, Item 10), screws (Figure 1, Item 11), and auxiliary
fuel pump (Figure 1, Item 5).
6. If necessary, remove elbow (Figure 1, Item 12) and elbow (Figure 1, Item 13).
7. Disconnect two hoses (Figure 1, Item 14) and (Figure 1, Item 15) from solenoid valve (Figure 1, Item 8).
8. Remove two screws (Figure 1, Item 16) and solenoid valve (Figure 1, Item 8).
9. If necessary, remove two elbows (Figure 1, Item 17).
0059-2
