TM 9-6115-730-24
0052
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch
is OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open right rear doors.
3. Open left rear doors.
NOTE
Each current transformer has two cables running through it. These cables must be disconnected
at one end in order to remove the current transformer.
Cut tiedown straps as required.
4. Tag and disconnect cables running through three current transformers (Figure 1, Sheet 1, Item 1. Tag and
remove sensor wires located on top of current transformers.
5. Remove twelve screws (Figure 1, Sheet 1, Item 2), washers (Figure 1, Sheet 1, Item 3), lockwashers
(Figure 1, Sheet 1, Item 4), and three current transformers (Figure 1, Sheet 1, Item 1).
6. If necessary, remove four screws (Figure 1, Sheet 1, Item 5), washers (Figure 1, Sheet 1, Item 6),
lockwashers (Figure 1, Sheet 1, Item 7), and current transformer bracket (Figure 1, Sheet 1, Item 8).
7. Tag and disconnect cables running through three current transformers (Figure 1, Sheet 2, Item 9). Tag and
remove sensor wires located on top of current transformers.
8. Remove twelve screws (Figure 1, Sheet 2, Item 10), washers (Figure 1, Sheet 2, Item 11), lockwashers
(Figure 1, Sheet 2, Item 12), and three current transformers (Figure 1, Sheet 2, Item 9).
9. Tag and disconnect cable running through current transformer (Figure 1, Sheet 2, Item 13. Tag and remove
sensor wires located on top of current transformers.
10. Remove four screws (Figure 1, Sheet 2, Item 14), washers (Figure 1, Sheet 2, Item 15), lockwashers
(Figure 1, Sheet 2, Item 16), and current transformer (Figure 1, Sheet 2, Item 13).
END OF TASK
INSTALLATION
1. Put one end of cables through current transformer (Figure 1, Sheet 2, Item 13) to be installed above two
power transformers, remove tag, and connect end of cable.
2. Install current transformer (Figure 1, Sheet 2, Item 13), four lockwashers (Figure 1, Sheet 2, Item 16),
washers (Figure 1, Sheet 2, Item 15), and screws (Figure 1, Sheet 2, Item 16). Connect sensor wires to
current transformer (Figure 1, Sheet 2, Item 13).
3. Put one end of cables through each of three current transformers (Figure 1, Sheet 2, Item 9) to be installed
above the generator, remove tags, and connect end of each cable.
4. Install three current transformers (Figure 1, Sheet 2, Item 9), six lockwashers (Figure 1, Sheet 2, Item 12),
washers (Figure 1, Sheet 2, Item 11), and screws (Figure 1, Sheet 2, Item 10). Remove tags and connect
sensor wires located on top of current transformers.
0052-2
