TM 9-6115-730-24
0051
REMOVAL - Continued
NOTE
When looking into battery compartment, batteries are identified from left to right as BT4, BT2,
BT1, and BT3.
4. Tag and disconnect battery cables 1A40 (Figure 1, Item 1) and 1B40 (Figure 1, Item 2) from battery BT2
negative terminal (Figure 1, Item 3).
5. Tag and disconnect battery cables 1B40 (Figure 1, Item 2) and 1D40 (Figure 1, Item 4) from battery BT4
negative terminal (Figure 1, Item 5).
6. Tag and disconnect battery cables 12B40 (Figure 1, Item 6) and 12A40 (Figure 1, Item 7) from battery BT1
negative terminal (Figure 1, Item 8).
7. Tag and disconnect battery cable 12B40 (Figure 1, Item 6) from battery BT3 negative terminal (Figure 1,
Item 9).
8. Remove four screws (Figure 1, Item 10), lockwashers (Figure 1, Item 11), and washers (Figure 1, Item 12),
and pull battery disconnect switch (Figure 1, Item 13) away from wall.
9. At rear of battery disconnect switch (Figure 1, Item 13), tag and disconnect battery cables 1A40 (Figure 1,
Item 1) and 2A40 (Figure 1, Item 14).
10. Remove battery disconnect switch (Figure 1, Item 13). Tag and disconnect wires from BDS.
END OF TASK
INSTALLATION
1. Connect battery 2A40 (Figure 1, Item 14) and 1A40 and sensor cables (Figure 1, Item 1).
2. Install battery disconnect switch (Figure 1, Item 13) with four washers (Figure 1, Item 12), lockwashers
(Figure 1, Item 11), and screws (Figure 1, Item 10).
3. Remove tag and connect battery cable 12B40 (Figure 1, Item 6) to battery BT3 negative terminal (Figure 1,
Item 9).
4. Remove tags and connect battery cable 12A40 (Figure 1, Item 7) and 12B40 (Figure 1, Item 6) to battery BT1
negative terminal (Figure 1, Item 8).
5. Remove tags and connect battery cables 1B40 (Figure 1, Item 2) and 1D40 (Figure 1, Item 4) to battery BT4
negative terminal (Figure 1, Item 5).
6. Remove tags and connect battery cables 1A40 (Figure 1, Item 1) and 1B40 (Figure 1, Item 2) to battery BT2
negative terminal (Figure 1, Item 3).
7. Close battery access doors.
0051-2
