TM 9-6115-730-24
0050
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch
is OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Ensure there is no external cable connected to slave receptacle.
3. Open battery access doors.
NOTE
When looking into battery compartment, batteries are identified from left to right as BT4, BT2,
BT1, and BT3.
4. Tag and disconnect battery cables 1B40 (Figure 1, Item 1) and 1A40 (Figure 1, Item 2) from battery BT2
negative terminal (Figure 1, Item 3).
5. Tag and disconnect battery cable 12B40 (Figure 1, Item 4) from battery BT3 negative terminal (Figure 1,
Item 5) and from battery BT1 negative terminal (Figure 1, Item 6).
6. Tag and disconnect battery cables 1D40 (Figure 1, Item 7) and 1B40 (Figure 1, Item 1) from battery BT4
negative terminal (Figure 1, Item 8).
7. Tag and disconnect battery cable 12A40 (Figure 1, Item 9) from battery BT1 negative terminal (Figure 1,
Item 6) and battery BT2 positive terminal (Figure 1, Item 10).
8. Tag and disconnect battery cable 12C40 (Figure 1, Item 11) from battery BT2 positive terminal (10) and
battery BT4 positive terminal (Figure 1, Item 12).
9. Tag and disconnect battery cables 24A40 (Figure 1, Item 13) and 24B40 (Figure 1, Item 14) from battery BT1
positive terminal (Figure 1, Item 15).
10. Tag and disconnect battery cables 24B40 (Figure 1, Item 14) and 24H40 (Figure 1, Item 16) from battery BT3
positive terminal (Figure 1, Item 17).
11. Remove five nuts (Figure 1, Item 18), lockwashers (Figure 1, Item 19), washers (Figure 1, Item 20), and pull
battery hold down angle (Figure 1, Item 21) off five threaded rods (Figure 1, Item 22).
12. Remove battery BT4 (Figure 1, Item 23), battery BT2 (Figure 1, Item 24), BT1 (Figure 1, Item 25), and BT3
(Figure 1, Item 26).
0050-2