TM 9-6115-730-24
0018
DISASSEMBLY - Continued
3. Remove four nuts (Figure 1, Item 11), screws (Figure 1, Item 12), holding rod bracket (Figure 1, Item 13),
door holding rod (Figure 1, Item 14), and door holding bracket.
4. If necessary, remove foam damping.
END OF TASK
ASSEMBLY
1. If necessary, use old foam damping as template to cut new foam damping sheet.
2. Install foam damping.
3. Install door holding bracket (Figure 1, Item 15), door holding rod (Figure 1, Item 14), and holding rod bracket
(Figure 1, Item 13) and secure with four screws (Figure 1, Item 12) and nuts (Figure 1, Item 11).
4. Install two latches (Figure 1, Item 1) and secure with eight screws (Figure 1, Item 10) and nuts (Figure 1,
Item 9).
5. Install hinge (Figure 1, Item 8) and secure with seven screws (Figure 1, Item 7) and locknuts (Figure 1, Item
6).
END OF TASK
INSTALLATION
1. If removed, replace seal.
2. Install right battery access door (Figure 1, Item 2) and secure with seven screws (Figure 1, Item 5), washers
(Figure 1, Item 4), and locknuts (Figure 1, Item 3).
3. Close right battery access door (Figure 1, Item 2) and secure by rotating and closing two latches (Figure 1,
Item 1).
END OF TASK
END OF WORK PACKAGE
0018-3/4 blank
