TM 9-6115-730-24
0011
TROUBLESHOOTING FAILURES WITHOUT FAULT CODES - Continued
MALFUNCTION
Ether Injection System Malfunction.
CORRECTIVE ACTION
STEP 1.
Verify that Ether is enabled in the system configuration parameters (WP 0083).
NOTE
The Ether Injection System is active only during the following conditions:
The engine speed is less than 35 RPM.
The coolant temperature or the intake manifold air temperature is less than 32F
(0C).
STEP 2.
If these conditions are present, troubleshoot Ether Injection System (WP 0013,
SYMPTOM 4).
STEP 3.
If these conditions are not present, proceed to next malfunction.
STEP 4.
Verify the problem has been resolved.
MALFUNCTION
Winterization Kit Malfunction.
CORRECTIVE ACTION
STEP 1
On EMCP set ENGINE CONTROL switch to OFF/RESET. Set Battery
Disconnect Switch to OFF. Set DEAD CRANK SWITCH to OFF.
STEP 2.
If fuel-fired heater was on, check wiring and continuity between winterization kit
control panel and fuel-fired heater (FO-1, sheet 6).
a.
b.
Inspect and repair or replace heater hoses (WP 0091).
c.
d.
STEP 3.
Check for presence of congealed fuel (wax). If congealed fuel is found, drain tank
STEP 4.
Verify the problem has been resolved.
0011-24