TM 9-6115-730-24
0009
TROUBLESHOOTING USING GSC FAULT CODES - Continued
CORRECTIVE ACTION - Continued
STEP 5.
On the GSC relay module, measure resistance between RM-25 and RM-11.
Resistance should be greater than 5000 ohms. Measure resistance between
RM-26 and RM-10. Resistance should be less than 5 ohms.
STEP 6.
Set Battery Disconnect Switch to ON. Set DEAD CRANK SWITCH to NORMAL.
Turn ENGINE CONTROL switch to MANUAL START.
STEP 7.
Measure resistance between RM-25 and RM-11. Resistance should be less than
5 ohms. Measure resistance between RM-26 and RM-10. Resistance should be
greater than 5000 ohms.
STEP 8.
Turn the ENGINE CONTROL switch to OFF/RESET. Battery Disconnect Switch
is OFF; DEAD CRANK SWITCH is OFF.
STEP 9.
If any of the measurements fail, replace the GSC (WP 0041).
STEP 10.
Reinstall fuse A1F8 and A1F9 and reconnect wire(s) to GSC A1-26.
STEP 11.
Verify the problem has been resolved.
0009-44
