TM 9-6115-730-24
0008
TROUBLESHOOTING USING AL FAULT CODES - Continued
CORRECTIVE ACTION - Continued
STEP 4.
Verify if any faults are displayed on DVR. Check set points per WP 0083.
a. If no DVR fault codes are displayed, check ATB fuses (FO-1, Sheet 5).
b. If DVR fault code 701 is present, go to WP 0010, SYMPTOM 6 and
troubleshoot.
STEP 5.
Verify that the problem has been resolved.
STEP 6.
Troubleshoot per WP 0009, CID 1169 FMI 02, SYMPTOM 62.
STEP 7.
Verify if any fault codes displayed and record.
STEP 8.
If problem has not been resolved, troubleshoot per WP 0009.
STEP 9.
Verify that the problem has been resolved.
SYMPTOM
8.
AL 9
MALFUNCTION
CORRECTIVE ACTION
STEP 1.
On keypad, press ALARM CODES.
STEP 2.
Set Battery Disconnect Switch to ON. Set DEAD CRANK SWITCH to NORMAL.
Turn the ENGINE CONTROL switch to MANUAL START.
STEP 3.
On GSC keypad, press ALARM CODES.
STEP 4.
Verify AL9 appears on upper display.
STEP 5.
Verify if any fault codes or engine fault codes are displayed on upper display and
record.
a. Troubleshoot fault code and WP 0009, CID 362 E FMI 01 (SYMPTOM 42).
b. Verify OP5-0 engine/generator setpoints (WP 0083, Table 4).
STEP 6.
Verify the problem has been resolved.
SYMPTOM
9.
AL 10
MALFUNCTION
CORRECTIVE ACTION
STEP 1.
Set Battery Disconnect Switch to ON. Set DEAD CRANK SWITCH to NORMAL.
Turn the ENGINE CONTROL switch to MANUAL START.
STEP 2.
On GSC keypad, press ALARM CODES.
0008-6
