TM 9-6115-730-24
0004
TRANSIENT CODES DURING TROUBLESHOOTING
During troubleshooting, certain work packages may disconnect the harness from the rear of the GSC. This action
will cause failure codes unrelated to the actual failure to appear. Clear these created diagnostic codes after the
particular fault is corrected and the diagnostic code is cleared. When the harness connector is removed from the
GSC, the following diagnostic codes are recorded in a properly operating system.
CID 100 FMI 02 Engine Oil Pressure Sensor
CID 110 FMI 02 Engine Coolant Temperature Sensor
CID 111 FMI 03 Engine Coolant Level Sensor
CID 175 FMI 03 Engine Oil Temperature Sensor
CID 190 FMI 03 Engine Speed Sensor
CID 336 FMI 02 Engine Control Switch
Clear diagnostic codes after the problem is investigated or the problem is corrected. This will avoid confusion
during investigation of a future problem. The DIAG indicator is off when all diagnostic codes are cleared from the
fault log and no active diagnostic codes exist.
0004-8
