TM 9-6115-729-24
0094
INSTALLATION - Continued
NOTE
Replace heat shrink sleeving when soldering wiring on resistor leads.
2. To install resistor HTR1 (Figure 1, Item 4) or HTR2 (Figure 1, Item 5), position resistor and secure with two
screws (Figure 1, Item 7) and nuts (Figure 1, Item 6).
3. Connect spade terminals as follows:
HTR-1 lead 1 to TB4-10B
HTR-2 lead 1 to TB3-10B
HTR-1 lead 2 to HTR-2 lead 2
4. To install thermostat (Figure 1, Item 1), position thermostat and secure with two screws (Figure 1, Item 3) and
nuts (Figure 1, Item 2).
5. Connect spade terminals to TB 4 as follows:
Lead from TS-1 to TB 4-17
Lead from TS-2 to TB 4-12
6. Close control box panel and control box door.
END OF TASK
END OF WORK PACKAGE
0094-4
