TM 9-6115-729-24
0070
CAUTION
All fittings and openings must be capped or plugged immediately after opening to prevent
contamination of the air cleaner system.
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open left rear door.
3. Unfasten four clips (Figure 1, Item 1) and remove air cleaner cover (Figure 1, Item 2) and gasket (Figure 1,
Item 3) from air cleaner canister (Figure 1, Item 4).
CAUTION
Do not twist filter elements or filter elements may be damaged.
4. Pull out primary filter element (Figure 1, Item 5) and safety filter element (Figure 1, Item 6).
END OF TASK
INSPECTION
Inspect the air cleaner filter elements (TM 9-2350-729-10).
END OF TASK
CLEANING
WARNING
Cleaning with compressed air can cause flying particles. When using compressed air, wear
protective glasses and use clean, low pressure air, less than 30 psi (208 kPa). Failure to comply
can cause eye injury to personnel.
1. Clean filter elements with low pressure (less than 30 psi) compressed air.
2. Replace filter elements when damaged or they cannot be cleaned, or when restriction gauge (Figure 1, Item
7) stays red.
0070-2
