TM 9-6115-729-24
0029
ASSEMBLY
1. Install four screws (Figure 1, Item 22), nuts (Figure 1, Item 23) and coolant filler neck (Figure 1, Item 7).
2. Install exhaust out tube assembly (Figure 1, Item 21) into front roof section (Figure 1, Item 4) with four screws
(Figure 1, Item 19), and lockwashers (Figure 1, Item 20).
3. Install exhaust cover (Figure 1, Sheet 2, Item 18) using eight screws (Figure 1, Item 15), lockwashers (Figure
1, Item 16) and washers (Figure 1, Item 17) into front roof section (Figure 1, Item 4).
4. If necessary, use old foam damping sections as templates to cut new foam damping sections. Install twelve
foam damping sections, 64 push-on nuts (Figure 1, Item 14), and 97 clips (Figure 1, Item 13).
END OF TASK
INSTALLATION
1. Using two persons, align exhaust out tube assembly and install front roof section housing assembly (Figure 1,
Sheet 1, Item 4).
2. Install exhaust clamp (Figure 1, Sheet 1, Item 10) loosely between muffler and exhaust out tube assembly
(Figure 1, Sheet 1, Item 18) while front roof section is loose.
3. Secure front roof section housing assembly (Figure 1, Sheet 1, Item 4) with 43 washers (Figure 1, Sheet 1,
Item 3), lockwashers (Figure 1, Sheet 1, Item 2), and screws (Figure 1, Sheet 1, Item 1).
4. Install and tighten two screws (Figure 1, Sheet 1, Item 11) and lockwashers (Figure 1, Sheet 1, Item 12) on
exhaust muffler clamp (Figure 1, Sheet 1, Item 10) (access through access hole in cover).
5. Connect hose (Figure 1, Sheet 1, Item 6) to bottom of coolant filler neck (Figure 1, Sheet 1, Item 7) and tighten
clamp (Figure 1, Sheet 1, Item 5).
6. Route overflow hose (Figure 1, Sheet 1, Item 9) back through hole in front roof section (Figure 1, Sheet 1, Item
3) and connect hose to coolant filler neck (Figure 1, Sheet 1, Item 7) tighten clamp (Figure 1, Sheet 1, Item 8).
7. Install access covers (WP 0028).
END OF TASK
END OF WORK PACKAGE
0029-5/6 blank
