TM 9-6115-729-24
0027
DISASSEMBLY - Continued
3. Remove four nuts (Figure 1, Item 14), screws (Figure 1, Item 15), door holding bracket (Figure 1, Item 16),
door holding rod (Figure 1, Item 17), and holding rod bracket (Figure 1, Item 18).
4. Remove eight nuts (Figure 1, Item 19), screws (Figure 1, Item 20), and two latches (Figure 1, Item 1).
5. Remove seven foam damping sections as required.
END OF TASK
ASSEMBLY
1. If necessary, use old foam damping sections as templates to cut new foam damping sections.
2. Install seven foam damping sections.
3. Install two latches (Figure 1, Item 1), and secure with eight screws (Figure 1, Item 20) and nuts (Figure 1,
Item 19).
4. Install holding rod bracket (Figure 1, Item 18), door holding rod (Figure 1, Item 17), and door holding bracket
(Figure 1, Item 16), and secure with four screws (Figure 1, Item 15) and nuts (Figure 1, Item 14).
5. Install duct (Figure 1, Item 13) and secure with nine lockwashers (Figure 1, Item 12), washers (Figure 1, Item
11), and screws (Figure 1, Item 10).
6. Install hinge (Figure 1, Item 9) and secure with eight screws (Figure 1, Item 8) and nuts (Figure 1, Item 7).
END OF TASK
INSTALLATION
1. Install right rear door assembly (latch) and hinge (Figure 1, Item 2) and secure with eight screws (Figure 1,
Item 6), washers (Figure 1, Item 5), and lockwashers (Figure 1, Item 4).
2. Close right rear door assembly (Figure 1, Item 3) and right rear door assembly (latch) (Figure 1, Item 2) and
secure by rotating two latches (Figure 1, Item 1).
END OF TASK
END OF WORK PACKAGE
0027-3/4 blank
