TM 9-6115-729-24
0026
DISASSEMBLY - Continued
3. Remove four nuts (Figure 1, Item 13), screws (Figure 1, Item 14), door holding bracket (Figure 1, Item 15),
door holding rod (Figure 1, Item 16), and holding rod bracket (Figure 1, Item 17).
4. Remove seven foam damping sections as required.
END OF TASK
ASSEMBLY
1. If necessary, use old foam damping sections as templates to cut new foam damping sections.
2. Install five foam damping sections.
3. Install holding rod bracket (Figure 1, Item 17), door holding rod (Figure 1, Item 16), and door holding bracket
(Figure 1, Item 15), and secure with four screws (Figure 1, Item 14), and nuts (Figure 1, Item 13).
4. Install duct (Figure 1, Item 12) and secure with nine washers (Figure 1, Item 11), and screws (Figure 1, Item
10).
5. Install hinge (Figure 1, Item 9) and secure with eight screws (Figure 1, Item 8) and locknuts (Figure 1, Item 7).
END OF TASK
INSTALLATION
1. Install right rear door assembly and hinge (Figure 1, Item 3) and secure with eight lockwashers (Figure 1, Item
6), washers (Figure 1, Item 5), and screws (Figure 1, Item 4).
2. Close right rear door assembly (Figure 1, Item 3) and right rear door assembly (latch) (Figure 1, Item 2) and
secure by rotating two latches (Figure 1, Item 1).
END OF TASK
END OF WORK PACKAGE
0026-3/4 blank
