TM 9-6115-729-24
0025
DISASSEMBLY - Continued
3. Remove four nuts (Figure 1, Item 11), screws (Figure 1, Item 12), door holding bracket (Figure 1, Item 13),
door holding rod (Figure 1, Item 14), and holding rod bracket (Figure 1, Item 15).
4. Remove ten screws (Figure 1, Item 16), washers (Figure 1, Item 17), lockwashers (Figure 1, Item 18), and
deflector (Figure 1, Item 19).
5. Remove twelve screws (Figure 1, Item 20), washers (Figure 1, Item 21), lockwashers (Figure 1, Item 22), and
duct (Figure 1, Item 23).
6. Remove nine foam damping sections as required.
END OF TASK
ASSEMBLY
1. If necessary, use old foam damping sections as templates to cut new foam damping sections.
2. Install foam damping sections.
3. Install duct (Figure 1, Item 23) and secure with twelve lockwashers (Figure 1, Item 22), washers (Figure 1,
Item 21), and screws (Figure 1, Item 20).
4. Install deflector (Figure 1, Item 19) and secure with ten lockwashers (Figure 1, Item 18), washers (Figure 1,
Item 17), and screws (Figure 1, Item 16).
5. Install holding rod bracket (Figure 1, Item 15), door holding rod (Figure 1, Item 14), door holding bracket
(Figure 1, Item 13), and secure with four screws (Figure 1, Item 12), and nuts (Figure 1, Item 11).
6. Install two latches (Figure 1, Item 1) and secure with eight screws (Figure 1, Item 10) and nuts (Figure 1, Item
9).
7. Install hinge (Figure 1, Item 8) and secure with twelve screws (Figure 1, Item 7) and nuts (Figure 1, Item 6).
END OF TASK
INSTALLATION
1. Install right front door assembly (latch) and hinge (Figure 1, Item 2) and secure with twelve lockwashers
(Figure 1, Item 5), washers (Figure 1, Item 4), and screws (Figure 1, Item 3).
2. Close right front door assembly (latch) (Figure 1, Item 2) and secure by rotating and closing two latches
(Figure 1, Item 1).
END OF TASK
END OF WORK PACKAGE
0025-3/4 blank
