TM 9-6115-729-24
0013
ELECTRONIC TECHNICIAN (ET) TROUBLESHOOTING - Continued
CORRECTIVE ACTION - Continued
NOTE
Do not install the timing calibration probe over the timing pin hole in the flywheel. Damage to the
timing calibration probe will result.
STEP 5.
Install the 6V-2197 transducer as follows:
a. Apply clean oil to a 2D-6392 O-ring seal. Install the o-ring seal on the end of
the 6V-2197 transducer.
b. Insert the 6V-2197 transducer through the 7X-1171 transducer adapter.
Insert the transducer until contact is made with the surface of the flywheel.
Pull the transducer 1.0 mm (0.04inch) away from the flywheel.
c.
Tighten the nut on the transducer adapter.
d. Connect the 7X-1695 cable assembly from the engine timing calibration
probe (transducer) to the ENG-P10 timing calibration probe connector. Refer
to FO-2 Sheet 1. The ENG-P10 connector is located above the ECM.
STEP 6.
Connect the Cat ET to connector CDC-P7 (WP 0012).
