100 kW TACTICAL QUIET GENERATOR SET
Metal jewelry can conduct electricity and become entangled in generator set components. Remove
all metal jewelry when working on generator set. Failure to comply can cause injury or death to
High voltage is produced when this generator set is in operation. Make sure unit is completely shut
down and free of any power source before attempting any repair or maintenance on the unit. Failure
to comply can cause injury or death to personnel.
High voltage is produced when the generator set is in operation. Never attempt to start the
generator set unless it is properly grounded. Failure to comply can cause injury or death to
DC voltages are present at generator set electrical components even with generator set shut down.
Avoid shorting any positive with ground/negative. Failure to comply can cause injury to personnel
and damage to equipment.
The Troubleshooting Procedures (WP 0010 00) contain a table that lists the malfunctions, tests or inspections, and corrective
actions required to return the TQG to normal operation. The operator troubleshooting procedures cannot list all possible
malfunctions or tests and inspections required for corrective action. If a malfunction is not listed or is not corrected by the
listed corrective actions, notify maintenance immediately.
The WP 0010 00 INITIAL SETUP outlines what is needed for the task as well as certain conditions that must be met before
starting the task. Don't start a task until the following conditions exist:
You understand the task.
You understand what you are to do.
You understand what is needed to do the work.
You have the things you need.
WP 0010 00 Troubleshooting Table
1 has three columns: MALFUNCTION,
TEST OR INSPECTION, and CORRECTIVE
ACTION. Note that the malfunctions are also listed in the Malfunction/Symptom Index (WP 0009 00).
MALFUNCTIONs are numbered in sequence and are to be performed in the order in which they appear.
TESTs OR INSPECTIONs are steps you take to isolate the malfunction. Each test or inspection has a corrective action.
These are the "if" statements that tell you what to do when the malfunction is not fixed.
CORRECTIVE ACTIONs are actions intended to correct the problem. If the problem cannot be identified or corrected,
report the problem as follows: (US Army) report all deficiencies, including deficiencies that appear to involve unsatisfactory
design, on DA Form 5988-E, automated form in the Unit Level Logistics System (ULLS), generated Equipment
Maintenance and Inspection Worksheet. When no automation is available, use DA Form 2404 (Equipment Inspection and
Maintenance Worksheet). Both forms serve the same purpose. Air Force and Marine Corps report all deficiencies on SF