ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
(10) Take up the slack in recoil starter rope (1) and pull rope quickly and all the way out.
(11) If the engine fails to start, repeat steps 7 thru 10.
(12) If engine still fails to start after two attempts, refer to operator troubleshooting tables in
Chapter 3.
(13) Check all gauges for proper indications as follows, refer to Figure 2-1:
NOTE
If any gauge indicates an improper value, refer to the operator
troubleshooting tables in Chapter 3.
(a)
VOLTS AC meter (12) for 120 VAC (MEP-531A) or VOLTS DC meter (12)
for 28 VDC (MEP-501A).
(b)
HERTZ frequency meter (18) for 60-63 Hz (MEP-531A).
(c)
%LOAD meter (13) under no load condition should read 0 (%). The reading
will vary as the demand changes (from 0 to 125 %).
NOTE
Under normal conditions, allow the diesel engine to warm-up for five
minutes before applying a load. If necessary, the load can be applied
immediately.
(14) Switch ON-OFF load circuit breaker (10, Figure 2-1) to ON to apply load.
(15) Perform all D (During) PMCS procedures in accordance with Table 2-2.
