ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
2-39
(3). Type the following: a:\setup
(4). Left click on OK button. At this point the setup wizard will guide you through the installation.
When prompted hit "Next" and complete requested information. Keep hitting "Next" until prompted to
insert Disk 2. Insert 3.5" floppy disk labeled "Generator Software Remote Operator. Disk 2 of 2", in
3.5" floppy drive of computer.
(5). To start remote data display software, left click mouse on Windows 95 START button in the lower
left corner of the screen. The START menu will pop up on the screen.
(6). Select Programs, then left click the "Remote Data Display" icon. (Note: If the message "Error:
Communication Failed" comes up on the screen, click OK. This error may come up because the PC is
not connected to the CIM).
(7). To exit out of this screen, move cursor to EXIT button and left click the mouse.
2.14
PREPARATION FOR MOVEMENT.
a. Shut down generator set, paragraph 2.11.2. If generator set is operating in parallel, refer to paragraph
2.12.4.
b. Disconnect load cables (Figure 2-7).
c. Disconnect paralleling cable, if used, and store in storage box inside BATTERY ACCESS door (Figure
1-2).
d. When using auxiliary fuel line, disconnect line, drain excess fuel from line, and store line in storage
box inside BATTERY ACCESS door (Figure 1-2).
e. Disconnect ground cable, and remove ground rods. Store ground rods in holding brackets located
inside generator set housing, below engine compartment access doors. Store ground cable, couplings,
clamp, and driving stud in storage box inside BATTERY ACCESS door.
f.
Secure all generator set access doors and panels.
g. For assembly and preparation for use, refer to paragraph 2.9.
