ARMY TM 9-6115-670-14&P
6-80
6.32. RADIATOR SEAL FARING.
This task covers: Replace
INITIAL SETUP
Tools
General Mechanic's Tool Kit
(Item 1, Appendix B)
Shop Equipment, Electrical Repair,
Semitrailer Mounted
(Item 3, Appendix B)
Riveter
(Item 31, Appendix B)
Equipment Conditions
Engine shutdown and allowed to cool for ten
minutes.
Materials/Parts
Radiator Seal Faring
Rivets
(Item 15, Appendix F)
REPLACE
a. Set up a drill with a 3/16-in. bit dia. Drill out the heads of 14 rivets (4, Figure 6-29).
b. Remove rivets (4). Use a punch if necessary.
c. Remove four bolts and washers (3), nuts with captive washers (5), and pull handle (2) and
faring (1).
d. Install faring (1) and pull handle (2) and secure with four bolts and washers (3) and nuts with
captive washers (5).
e. Use riveter to secure faring (1) with 14 rivets (4).
NOTE
There is a difference between SICPS, JTACS and WIN-
T faring width.
NOTE
Do not install rivets in bolt holes for pull handle.
