ARMY TM 9-6115-670-14&P
5-88
c. Cut and remove tiedown straps as needed to remove wiring harness.
d. Remove wiring harness from generator housing.
e. Refer to old wiring harness and tag leads on new wiring harness.
f. Install connector J1 (4) and secure with four screws, (caged nuts (SICPS), machine screws
(JTACS and WIN-T)) (7), lock washers (3), and nuts (2).
g. Reconnect wiring harness electrical leads (1). Remove tags.
h. Secure wiring harness with tiedown straps as needed.
i. Install generator housing side cover (5) (muffler side) and secure with two screws, wing nuts
and lock washers (JTACS), or four slotted hex-head bolts (SICPS and WIN-T), flat and lock
washers (6).
j. Install generator housing side cover (8) (fuel transfer pump side) and secure with four screws
(JTACS), or slotted hex-head bolts (SICPS and WIN-T), flat and lock washers (9).
k. Install generator housing top cover (11) and secure with four screws (JTACS), or slotted hex-
head bolts (SICPS and WIN-T), flat and lock washers (10).
CAUTION
Take care not to cut wires or other APU components
when removing tiedown straps.
NOTE
Cut and remove tiedown straps as needed to remove
wiring harness.
NOTE
When removing, make note of tiedown strap locations.
Wiring harness will need to be secured at
approximately the same places.
