ARMY TM 9-6115-670-14&P
4-129
REPLACE
a. Remove one socket head screw (15), nut (24), and lock washer (25) securing rod end bearing (16)
of long actuator linkage rod (3) to clevis (2) and remove rod end bearing (16).
b. Remove one socket head screw (4), nut (12), and lock washer (11) securing rod end bearing (13) of
long actuator linkage rod (3) to pivot arm (10) and remove rod end bearing (13).
c. Remove one bolt (20), nut with captive washer (22) securing rod end bearing (5a) of short actuator
linkage rod (6) to governor arm (21) and remove rod end bearing (5a).
d. Remove one bolt (5), nut (9) and star lock washer (8) securing rod end bearing (7) of short actuator
linkage rod (6) to pivot arm (10) and remove rod end bearing (7).
e. Remove one shoulder bolt (19) securing pivot arm (10) to governor linkage pivot plate (23) and
remove pivot arm (10).
f. Unscrew and remove two rod end bearings (13 and 16) and two hex nuts (17 and 18) from long
actuator linkage rod (3).
g. Unscrew and remove two rod end bearings (5a and 7) from short actuator linkage rod (6).
h. Unscrew and remove clevis (2) and stop nut (1) from actuator shaft (14).
i. Install stop nut (1) fully onto actuator shaft (14).
j. Install clevis (2) on actuator shaft (14) and turn until fully against stop nut (1).
k. Install two rod end bearings (5a and 7) on short actuator linkage rod (6).
l. Adjust distance between rod end bearings to obtain a length of 2 3/8 in. (6.08 cm).
m. Install two hex nuts (17 and 18) and two rod end bearings (13 and 16) on long actuator linkage rod
(6).
n. Adjust distance between rod end bearings to obtain length of 6-11/16 in. (16.986 cm).
o. Install pivot arm (10) on governor linkage plate (23) and secure with one shoulder bolt (19).
p. Install rod end bearing (5a) of short actuator linkage rod (6) on governor arm (21) and secure with
one bolt (20), and nut with captive washer (22).
q. Install remaining rod end bearing (7) of short actuator linkage rod (6) on pivot arm (10) and secure
with one bolt (5), nut (9) and star lock washer (8).
r. Install rod end bearing (13) of long actuator linkage rod (3) on pivot arm (10) and secure with one
socket head screw (4), lock washer (11) and nut (12).
s. Install remaining rod end bearing (16) of long actuator linkage rod (3) on clevis (2) and secure with
socket head screw (15), lock washer (25), and nut (24).
