TM 9-6115-664-13&P
5-17. OIL COOLER MAINTENANCE
This task covers removal, inspection, and installation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
Engine/Alternator Removed (Para. 5-7)
and Repair (Item 4, App. B)
Oil Cooler Hoses Disconnected (Para. 4-38)
A.
REMOVAL.
1.
If replacement is required, remove sound-proofing material (1, Figure 5-11) from inside of enclosure by removing
dome washers (2).
2.
Remove engine mount (Para. 5-7).
3.
Remove oil cooler guard (3) from enclosure by removing eight screws (4), washers (5), and four locknuts (6).
4.
Remove oil cooler (7) from enclosure by removing six screws (12) and lockwashers (13) securing front portion of
mounting block (11).
5.
If replacement is required, remove eight split bushings (14) from oil cooler (7).
6.
If replacement is required, remove rear portion of mounting blocks (11) from enclosure by removing four screws (8),
lockwashers (9), and washers (10).
B.
INSPECTION..
1.
Inspect oil cooler for obvious damage. Inspect for evidence of leakage or corrosion. Inspect oil cooler fins for
damage and straighten as required.
2.
Inspect edge seal on oil cooler guard for damage. Remove and replace as required.
3.
Inspect rubber grommets on oil cooler cover for damage. Replace as required.
5-58
