TM 9-6115-664-13&P
5-16. ALTERNATOR MAINTENANCE
D.
INSTALLATION.
1.
Apply silicon adhesive and foam insulating tape in accordance with notes made during removal.
2.
Install four sleeves (28, Figure 5-10), screws (29), and washers (30) onto metal flex coupling (21).
3.
Mate flywheel housing (2) to alternator and secure using four screws (25), washers (26), and lockwashers (27).
4.
Install flex coupling (21) onto alternator shaft (22) so that keyway is aligned over key. Secure by tightening coupling
setscrew. Install nut (23) and washer (24).
5.
Install mounting blocks (13) over alternator fan and secure using screws (18), washers (19), and nuts (20). Install
screw (14), washers (15, 16), and locknut (17) into lower mounting bracket.
6.
Install voltage regulator (6) onto alternator using screw (7), washer (8), and lockwasher (9).
7.
Fit alternator fan shroud (10) onto mounting blocks (13) and secure using six screws (11), washers (12), and nuts
(13).
8.
Fit flywheel shroud (1) onto alternator and mate to flywheel housing (2). Secure using two screws (3), lockwashers
(4), and washers (5).
9.
Install engine (Para. 5-8).
5-57
