4-4. Reinstallation
TM 9-6115-650-14&P
After Movement. After movement to a new worksite, install power plant in
accordance with paragraph 4-2.
Section Ill. REPAIR PARTS, SPECIAL TOOLS, SPECIAL TEST, MEASUREMENT AND
DIAGNOSTIC EQUIPMENT (TMDE)
4-5. Tools and Equipment. There are no special tools or equipment required to maintain the AN/MJQ-25
power plant.
4-6. Maintenance Repair Parts. Repair parts and equipment for maintenance of this power plant are listed
and illustrated in the repair parts and special tools list in Appendix D of this manual.
Section IV. LUBRICATION INSTRUCTIONS
4-7. General. Detailed instructions for the lubrication of the major components of the power plant are contained
in the applicable Lubrication Orders (LO’s). Refer to DA Pam 25-30 to insure that the latest editions of the L.O.’s
are used. This section contains lubrication instructions that are not included in the Lubrication Orders.
4-8. Generator Lubrication. Refer to TM 5-6115-585-12.
4-9. Trailer Assembly Lubrication.
a. Trailer Lubrication. Refer to TM 9-2330-213-14&P for trailer Lubrication Order.
b. Leg Prop Ass embly Lubrication. The rear leg prop assembly is a modification to the standard M103A3 trailer
and, as such, does not appear in the associated LO. Semiannually lubricate leg prop assembly as follows:
WARNING
Clean parts in a well-ventilated area. Avoid inhalation of solvent fumes and prolonged
exposure of skin to cleaning solvent. Wash exposed skin thoroughly. Dry cleaning
solvent (PD-680) used to clean parts is potentially dangerous to personnel and property.
Do not smoke or use near open flame or excessive heat. Flash point of solvent is 100°F.
to 138°F. (38°C. to 59°C.).
(1) Clean hydraulic lubrication fitting and area around lubrication points with PD-680 or equivalent.
(2) Inject sufficient GAA grease into hydraulic fitting to lubricate screw threads inside leg prop assembly.
NOTE
Refer to Lubrication Order in TM 9-2330-213-14&P for lubricating oils specified for use
within different anticipated temperature ranges.
(3) Apply OE lubricating oil to both ends of leg prop assembly pivot shaft.
4-7
