TM 9-6115-646-14&P
(2)
Position hammer bracket (11) on plate (4) and install two screws (8), two flat washers (9), and two nuts (10)
(3)
Position plate (4) on trailer with spacer (7) between plate and front step support (6)
(4)
Install eight screws (1), sixteen flat washers (2) and eight nuts (3)
(5)
Install accessory stowage chest and bracket on plate See paragraph 4-17
4-22 Cover Plate Replacement.
(See figure 4-10) The cover plates are mounted on either side of the trailer to
provide personnel access to the generator set The roadside and curbside cover plates are symmetrical and replacement
procedures are the same for both
a
Removal.
(1)
Remove six screws (1, figure 4-10), twelve flat washers (2), and six nuts (3) securing cover plate (4) to fender
bracket (5).
(2)
Remove six screws (6), twelve flat washers (7), and six nuts (8) securing cover plate (4) to trailer frame (9)
(3)
Lift cover plate (4) off trailer frame (9) and slide plate out from under fender brace (10)
b
Installation
(1)
Slide cover plate (4) under fender brace (10) and position plate on trailer frame (9)
(2)
Install six screws (6), twelve flat washers (7), and six nuts (8) securing cover plate (4) to trailer frame (9) and
tighten
(3)
Install six screws (1), twelve flat washers (2), and six nuts (3) securing cover plate (4) to fender bracket (5) and
tighten
4-19
