TM 9-6115-646-14&P
(3)
Install, but do not tighten, three screws (6), six flat washers (7) and three nuts (8) securing front step (4) to fender
bracket (9)
(4)
Install, but do not tighten, four screws (1), eight flat washers (2), and four nuts (3) securing front step (4) to trailer
frame (5)
(5)
After all hardware Is Installed, tighten hardware to secure front step (4) to trailer
4-20 Rear Step Replacement. (See figure 4-8 ) The roadside and curbside rear steps are symmetrical, and replacement
procedures are the same for both
a.
Removal.
(1)
Remove four screws (1, figure 4-8), eight flat washers (2) and four nuts (3) securing rear step (4) to trailer frame
(5)
(2)
Remove three screws (6), six flat washers (7), and three nuts (8) securing rear step (4) to fender bracket (9)
NOTE
When replacing rear step, remove and retain reflector and associated screws for installation on new rear
step
(3)
Remove two screws (10) and reflector (11)
b
Installation.
(1)
Position rear step (4) on trailer frame (5) and Install, but do not tighten, four screws (1), eight flat washers (2), and
four nuts (3)
(2)
Install, but do not tighten, three screws (6), six flat washers (7), and three nuts (8) securing rear step (4) to fender
bracket (9)
(3)
After all hardware Is Installed, tighten hardware to secure rear step (4) to trailer
NOTE
If Installing new rear step, reinstall reflector retained during removal procedure
(4)
Position reflector (11) on rear step (4) and install two screws (10)
4-16