2-8
ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
SECTION Il. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIP-
MENT (TMDE); AND SPECIAL SUPPORT EQUIPMENT
2-4 REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL).
2-4.1
Tools and Equipment. There are no special tools or support equipment required to perform unit level of mainte-
nance on the generator set. A list of recommended tools and support equipment required to maintain the generator set
is contained in Appendix B, SECTION Ill.
24.2 Maintenance Repair parts. Repair parts and equipment are listed and illustrated in the Repair Parts and Special
Tools List (RPSTL) manual TM 9-6115-645-24P.
SECTION Ill. SPECIAL LUBRICATION INSTRUCTIONS
NOTE
There are no special lubrication instructions. Refer to LO 9-6115-645-12 for generator
set lubrication requirements.
SECTION IV. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
2-5
PMCS PROCEDURES.
2-5.1
General. To ensure that the generator set is ready for operation at all times, it must be inspected so that defects
can be identified and corrected before they result in serious damage or failure.
2-5.2 Purpose of PMCS Table. Your Preventive Maintenance Checks and Services table lists the inspections and care
of your equipment required to keep it in good operating condition.
2-5.3
Purpose of Service IntervaIs. The interval column of your PMCS table tells you when to do a certain check or
service.
2-5.4 Procedures Column. The procedures column of your PMCS table tells you how to do the required checks and
services. Carefully follow these instructions.
2-5.5
The “Equipment Is Not Ready/Available If”. This column tells you when and why the generator set cannot be
used.
NOTE
The terms ready/available and mission capable refer to the same status: Generator set
is on hand and is able to perform its combat missions (see DA Pam 738-750).
2-5.6
Reporting and Correcting Deficiencies. If your generator set does not perform as required, refer to Troubleshoot-
ing section for possible problems. Report any malfunctions or failures on DA Form 2404, or refer to DA Pam 738-750.
