ARMY TM 9-6115-644-24
AIR FORCE 1025C2-4-446-12
MARINE CORPS TM 09249A/09246A-24/2
2-112-3 Repair.
Repair diode assembly (13, FIGURE 2-30) by replacing damaged terminal ends.
2-112-4 Installation.
a.
Position diode assembly (13, FIGURE 2-30) on fuel injection pump with band end toward engine.
b. Secure diode assembly (13) to fuel injection pump with nuts (12).
c.
Close left side engine access doors.
d. Connect negative battery cable and dose battery access door.
Section XVI. MAINTENANCE OF LUBRICATION SYSTEM
2-113 OIL DRAIN VALVE.
2-113-1
a.
b.
c.
d.
2-113-2
a.
b.
c.
d.
e.
f.
9-
2-113-3
a.
b.
c.
d.
e.
f.
2-160
lnspection.
Shut down generator set.
Open battery and right side engine access doors.
Inspect oil drain line for cracks, holes, loose or missing hardware, and other damage.
Close battery and right side engine access doors.
Removal.
Shut down generator set.
Open battery access door and disconnect negative battery cable.
Open right side engine access doors.
Remove plug (1, FIGURE 2-31), open drain valve (2) and drain engine oil into suitable container.
Loosen damp (3) and remove oil drain hoses from adapter (5).
Remove drain valve (2) from skid fitting.
Remove adapter (5) and pipe fitting (6) from oil drain valve (2).
Install adapter (5, FIGURE 2-31) and pipe fitting (6) in oil drain valve (2).
Install drain valve (2) on skid fitting.
Install oil drain hose on adapter (5). Secure with damps (3).
Ensure drain valve (2) is dosed, install plug (1) and service engine oil, paragraph 2-1-2-4.
Check engine oil drain valve for leakage.
Connect negative battery cable. Close battery and right side engine access doors.
I n s t a l l a t i o n.
