ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
a.
Shut down generator set.
b.
Remove coolant high temperature switch, paragraph 2-109-2.
WARNING
Dry cleaning solvent is flammable and toxic to eyes, skin, and respiratory tract.
Skin/eye protection required. Avoid repeated/prolonged contact. Good general
ventilation is normally adequate.
WARNING
Use low pressure air, 15 psi maximum. Wear protective glasses when using
compressed air. Failure to follow this warning could result in severe personal injury.
c.
Clean high temperature switch with dry, filtered compressed air and cleaning cloth (Item 8, Appendix
C) lightly moistened with dry cleaning solvent (Item 20, Appendix C).
d.
Inspect high temperature switch for cracked casing, corrosion, stripped or damaged threads, and
bent or broken connector pins.
e.
If no repair is needed, install coolant high temperature switch, paragraph 21094.
2-109-4
Installation.
a.
Install coolant high temperature switch (5, FIGURE 2-30) in lower thermostat housing.
b.
Connect electrical leads, remove tags and close left side engine access doors.
C.
Connect negative battery cable and close battery access door.
2-110 MAGNETIC PICKUP.
2-110-1
Removal.
a.
Shut down generator set.
b.
Open battery access door and disconnect negative battery cable.
c.
Open left side engine access doors, tag and disconnect magnetic pickup (6, FIGURE 2-30) electrical
leads.
d.
Loosen lock nut (6A) and remove magnetic pickup (6) and reducer bushing (7) from flywheel
housing.
2-110-2
Cleaning and Inspection.
a.
Shut down generator set.
b.
Remove magnetic pickup, paragraph 2-110-1.
WARNING
Dry cleaning solvent is flammable and toxic to eyes, skin, and respiratory tract.
Skin/eye protection required. Avoid repeated/prolonged contact. Good general
ventilation is normally adequate.
WARNING
Use low pressure air, 15 psi maximum. Wear protective glasses when using
compressed air. Failure to follow this warning could result in severe personal injury.
Change 1 2-157
