ARMY TM 9-6115-642-24
AIR FORCE TO 35C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
2-15.4. Installation.
a.
Install schematic diagram (30, FIGURE 2-6) on document box (21) with rivets (29).
b.
Install lifting and tiedown plate (26) and battery connection plate (28) on right side engine access door
(18) with rivets (25) and (27).
c.
Install latches (24) on right side engine access door (18) with screws (22) and nuts (23)
d.
Install document box (21) on right side engine access door (18) with bolts (19) and nuts (20).
e.
Install hinges (17) and right side engine access door (18) on generator set with bolts (13), washers (14),
lockwashers (15), and nuts (16).
f.
Install door holding bracket (10) and door link support (11) on door link flange (12) with screws (8) and
(9), spacers (6) and (7), washers (5), and nuts (4).
g.
Install door hold open mechanism (3) on generator set and right side engine access door (18) with bolts
(1) and nuts (2).
2-16. CONTROL BOX TOP PANEL.
2-16.1. Removal.
a.
Shut down generator set.
b.
Open left side engine access door and disconnect negative battery cable
c.
Remove control panel access door, paragraph 2-15.2.
The control box top panel is attached to the generator set with a silicone sealant to
prevent water from entering the control box. It will be necessary to pry the control box
top panel to separate it from the generator set. Care must be taken not to bend, scratch,
or otherwise damage the panel or the generator set.
d.
Remove bolts (1, FIGURE 2-7), nuts (2) and top panel (3).
e.
If damaged, remove gasket (8)
f.
Remove bolts (4), nuts (5) bracket (6), and ring (7) from top panel (3).
2-16.2. Inspection.
a.
Shut down generator set.
b.
Inspect control box top panel for dents, cracks, loose paint, and corrosion
2-16.3. Repair.
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC paint
dust is a health hazard and could cause personal injury if warning is not followed.
a.
Repair all dents and cracks, and remove all loose paint.
b
Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
c.
Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives
Change 4 2-37
