ARMY TM 9-6116-642-24
AIR FORCE TO 36C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
o.
p.
Install control box
Connect negative
top panel, paragraph 2-16.4.
battery cable and close access doors.
FIGURE 4-22. Testing Stator Windings
4-11 GENERATOR ASSEMBLY (MEP_803A).
4-11.1
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
Shut down generator set.
Remove rear housing section, paragraph 2-20.1.
Remove generator mounting hardware, paragraph 3-6.1, step z.
lnsertwooden wedges between rear endof engine and skid base to support engine when generator is removed.
Remove bolts (1, FIGURE 4-24) and end bell cover (2).
Remove nuts (3), washers (4), and end bell (5).
Tag and disconnect exciter stator leads (6) and AC voltage regulator leads (7) from terminal block (13) in end
bell (5).
Remove bolts (8), washers (9), brushless exciter stator (10), and packing (11) from end bell (5).
Remove bolts (12) and terminal board (13) from end bell (5).
Use care to avoid contact between stator (14) and rotor assembly (16).
Using lifting device attached to stator (14) lifting point, carefully pry loose (screwdriver slots provided), and re-
move stator (14) from engine/generator adapter (15).
Use rope sling to support rotor (16), refer to FIGURE 4-23.
FIGURE 4-23. Support of Rotor Assembly
4-24
Removal/Disassembly