ARMY TM 9-6115-642-24
AIR FORCE TO 35C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
o
Secure terminal board assembly to generator set skid with bolts (4), lockwashers (2), washers (3)
and nuts (1).
p
Connect load cables and close access door.
q
Connect negative battery cable and close access door
2-98. LOAD OUTPUT TERMINALS
2-98.1 Removal.
a
Shut down generator set
b
Open left side engine access door and disconnect negative battery cable.
c
Open load terminal board access door and disconnect load cables
d.
Remove load output terminal board assembly from generator set, paragraph 2-97.1, steps c thru g.
e.
Remove nuts (38, FIGURE 2-26), copper washers (39), and load terminals (12) from load output
terminal board assembly.
2-98.2. Inspection
a
Remove load output terminals, paragraph 2-98.1.
b.
Inspect load terminals for stripped threads or other obvious damage
c.
Replace damaged load terminals as necessary.
d
Install load output terminals, paragraph 2-98.3
2-98.3. Installation
a
Install load output terminals (12, FIGURE 2-26) on load output terminal board assembly with copper
washers (39) and nuts (38).
NOTE
Ensure GND load terminal passes through ground plane bracket (5) and LO load
terminal passes through bus bar (17).
b
Install load output terminal board assembly in generator set, paragraph 2-97.4, steps k thru n
c
Connect load cables and close load terminal board access door
d
Connect negative battery cable and close left side engine access door.
2-99
VARISTORS.
2-99.1 Removal.
a
Shut down generator set.
b
Open left side engine access door and disconnect negative battery cable
c
Remove load output terminal board assembly from generator set, paragraph 2-97.1, steps c thru g.
d.
Tag and disconnect varistor leads, (11, FIGURE 2-26) from varistors (25).
e.
Remove nuts (40), bolts (41), and varistors (25) from load output terminal board assembly
2-130 Change 4
