ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
2-98-3. Installation.
a.
Install load output terminals (12, Figure 2-26) on load output terminal board assembly with copper washers
(39) and nuts (38).
NOTE
Ensure GND load terminal passes through ground plane bracket (5) and LO load termi-
nal passes through bus bar (17).
b.
Install load output terminal board assembly in generator set, paragraph 2-97-4, steps k thru m.
c. Connect load cables and close load terminal board access door.
d. Connect negative battery cable and close left side engine access door.
2-99. VARISTORS.
2-99-1. Removal.
a.
Shut down generator set.
b. Open left side engine access door and disconnect negative battery cable.
c.
Remove load output terminal board assembly from generator set, paragraph 2-97-1, steps c thru g.
d. Tag and disconnect varistor leads, (11, Figure 2-26) from varistors (25).
e.
Remove nuts (40), bolts (41), and varistors (25) from load output terminal board assembly.
2-99-2. lnspection.
a. Remove varistors, paragraph 2-99-1.
b.
Inspect varistors for obvious external damage.
c.
Set multimeter for ohms and test each varistor by connecting multimeter to varistor terminals 1 and 2. Note
multimeter indication.
d. Reverse multimeter leads and note multimeter indication.
e.
Multimeter indications should be infinite ohms in both direction.
f.
Varistors are defective and must be replaced if indications are other than above.
g.
Install varistors, paragraph 2-99-3.
2-99-3. Installation.
a.
Install varistors (25, Figure 2-26), on load output terminal board assembly with bolts (41) and nuts (40).
b.
Connect varistor leads (11) to varistors (25) and remove tags.
c.
Install load output terminal board assembly in generator set, paragraph 2-97-4, steps k thru m.
d. Connect negative battery cable and close left side engine access door.
Section XVIIl. PREPARATION FOR SHIPMENT AND STORAGE
2-100. PRESERVATION.
a.
Preserve generator sets in accordance with levels A, B, or C of MIL–G-28554.
b. Preserve generator set cooling systems in accordance with method II of MIL–G–28554 or the antifreeze and
water procedure of Ml L–E–10062.
2-101. PACKING.
Pack generator sets in accordance with levels A, B or C of MIL-G-28554.
2-136
