ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
CHAPTER 3
GENERAL MAINTENANCE INSTRUCTIONS
Section 1. REPAiR PARTS; TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SPECIAL SUPPORT EQUIPMENT
3-1. MAINTENANCE REPAIR PARTS.
Repair parts are listed and illustrated in the repair parts and special tools list manual TM 9-6115-641-24P.
3-2. TOOLS AND EQUIPMENT.
There are no special tools or support equipment required to perform any level of maintenance on the generator set. A
list of recommended tools and support equipment required to maintain the generator set is contained in Appendix B,
Section Ill.
3-3.
FABRIC OF TOOLS AND EQUIPMENT.
There is no requirement for fabrication of tools and equipment for the maintenance of the generator set.
Section II. TROUBLESHOOTING
3-4. DIRECT SUPPORT TROUBLESHOOTING PROCEDURES.
3-4-1.
Purpose of Troubleshooting Table. This section contains troubleshooting information for locating and correcting
operating troubles which may develop in the generator set. Each malfunction for an individual component, unit, or system
is followed by a list of tests or inspections which will help you to determine probable causes and corrective actions to take.
You should perform the tests/inspections and corrective actions in the order listed.
This table cannot list all malfunctions that can occur, nor all tests or inspections and corrective actions. If a malfunction
is not listed or cannot be corrected by listed corrective actions. notify your supervisor.
NOTE
Before you use this table, be sure you have performed your PMCS.
NOTE
Refer Diagnostic Connector Table 2–10 to the Electrical Schematic FO–1 and Wiring
Diagram FO–2 as troubleshooting aids.
3-1
