ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
2-86-2. Removal.
a.
b.
c.
d.
e.
f.
g.
h.
Shut down generator set.
Open left side engine access door and disconnect negative battery cable.
Remove control box assembly, paragraph 2-21-2.
Loosen output box mounting hardware to allow access to fuel filter/water separator fuel lines.
Disconnect fuel outlet line (9, Figure 2-22), inlet line (2), and water drain line (10) from fuel filted/water
separator assembly. Cap all lines.
Remove bolts (11), washers (12), nuts (13), lockwashers (14), and fuel filter/water separator assembly from
generator set.
Remove fuel filter/water separator element, paragraph 2-87-1.
Remove fittings (17) and (18) from base (15).
2-86-3. Repair.
Repair assembly by replacing fuel filter/water separator element.
2-86-4. Installation.
a.
Install fittings (17 and 18, Figure 2-22) in base (15).
b. Install fuel filter/water separator element, paragraph 2-87-3.
c.
Install fuel filter/water assembly in generator set with bolts (11), washers (12), Iockwashers (14), and nuts (13).
d. Remove caps and connect water drain line (10), fuel outlet line (9), and fuel inlet line (2) to fuel filter/water sepa-
rator assembly.
e.
Tighten output box mounting hardware.
f.
Install control box assembly, paragraph 2-21-4.
g.
Connect negative battery cable and close access door.
2-87. FUEL FILTER/WATER SEPARATOR ELEMENT.
2-87-1. Removal.
a.
Shut down generator set.
b. Open left side engine access door and disconnect negative battery cable.
c.
Disconnect water drain line (10, Figure 2-22) from element (16).
d. Unscrew and remove fuel filter/water separator element (16) from base (15).
2-87-2. Inspection.
a.
Remove fuel filter/water separator element, paragraph 2-87-1.
b. Inspect element for clogging, tears, and other damage.
c.
Install fuel filter/water separator element, paragraph 2-87-3.
2-87-3. Installation.
a.
Open petcock valve on fuel filter/water separator.
b. Apply a film of engine oil (11, Appendix C) to the sealing surface of fuel filter/water separator.
c.
Install fuel filter/water separator element (16, Figure 2-22) on base (15). Hand-tighten only.
d. Connect water drain line (10) to element (16).
e.
Close petcock valve on fuel filter/water separator. Hand-tighten only.
f.
Connect negative battery cable and close access door.
2-120 Change 1
