ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
a.
b.
c.
d.
e.
2-80-3.
a.
b.
c.
d.
e.
Shut down generator set.
Open left side engine access door and disconnect negative battery cable.
Identify fuel line to be removed as shown in Figure 2-21 or Figure 2-22.
Disconnect fittings at both ends of fuel line and remove any clamps. Cap openings.
Remove fuel line from generator set.
Remove any caps and position fuel line in generator set.
Install any clamps as removed and connect fittings at both ends of fuel line.
Connect negative battery cable.
Turn MASTER SWITCH to PRIME& RUN or PRIME & RUN AUX FUEL position as applicable, and check for
fuel leaks.
Close all access doors.
2-81. FUEL TANK FILLER NECK.
2-81-1.
a.
b.
c.
d.
e.
f.
g.
2-81-2.
a.
b.
c.
d.
e.
2-81-3.
a.
b.
c.
d.
e.
f.
Removal.
Shut down generator set.
Open left side engine access door and disconnect negative battery cable.
Remove front panel, paragraph 2-18-1.
Remove filler cap (21, Figure 2-21). Rotate tube (22) one quarter turn counterclockwise, and remove from filler
neck (27).
Remove bolts (23) and nuts (24).
Remove clamps (25), rubber collar (26), and filler neck (27) from fuel tank opening.
Cover fuel tank opening.
Inspection.
Shut down generator set.
Remove front housing panel, paragraph 2-18-1.
Inspect rubber collar (26, Figure 2-21) for cracks, wear, or other damage.
Inspect filler neck (27), clamps (25), tube (22), and cap (21) for corrosion, cracks, or other damage.
Install front housing panel, paragraph 2-18-4.
Position filler neck (27, Figure 2-21) onto fuel tank opening.
Install rubber collar (26) and clamps (25) onto filler neck (27) and fuel tank opening.
Install bolts (23) and nuts (24).
Install filler cap (21) and tube (22).
Install front panel, paragraph 2-18-4.
Connect negative battery cable and close access door.
2-82. FUEL TANK DRAIN VALVE.
2-82-1. Removal.
Change 1 2-113
Installation.
Installation.
