TM 5-6115-632-14&P
Table 3-2. Operator/Crew Preventive Maintenance Checks and Services (PMCS) – CONT.
B – Before
D – During
A – After
W – Weekly
M – Monthly
Item
no.
28
Interval
Item to be inspected.
Procedure: check for and
have repaired, filled, or
adjusted as needed
FIRE EXTINGUISHER
Inspect and weigh fire extinguisher.
(See paragraph 3-12.)
TRAILER FRAME
Inspect entire chassis frame for
damage, cracks, and broken welds.
Section IV. TROUBLESHOOTING
3-10.
Power Unit Troubleshooting. There are no troubleshooting procedures authorized at operator
level for the power unit end item. Troubleshooting procedures for the individual generator set and
trailer are contained in their respective technical manuals referenced below.
a. Generator Set Troub/eshooting. Refer to TM 5-6115-585-12 for troubleshooting procedures.
b. Trailer Troubleshooting. Refer to TM 9-2330-202-14&P for troubleshooting procedures.
Section V. OPERATOR/CREW MAINTENANCE
3-11.
Enclosure Maintenance. Maintenance of the enclosure at operator level is limited to replace-
ment of the fitted cover and/or the bows.
a. Fitted Cover Replacement. (See figures 3-1 and 3-2.)
(1) removal.
Equipment is not
ready/available if:
Frame is obviously
broken or cracked.
(a)
(b)
(c)
(d)
(e)
Untie 27 ropes (1, figure 3-1) fastening fitted cover to trailer body (2).
Unfasten six straps and buckles (3) securing rear curtain (4). Roll up curtain, and
secure with three rollup straps (5) provided.
Unfasten six straps and buckles (3) securing front curtain (6). Roll up curtain, and
secure with three rollup straps (5) provided.
Roll up each side (7) of fitted cover, in turn, and secure each side with four rollup straps
(5) provided.
Working under fitted cover (1, figure 3-2), unfasten eight straps (2) securing fitted
cover to bow assemblies (3). Remove fitted cover.
3-17
