(7)
(8)
(9)
(10)
(11)
Remove two screws (9), two spacers
assembly (12) from trailer chassis (5).
TM 5-6115-630-14&P
10), and two nuts (11) and remove roadside handbrake lever
Remove cotter pin (13), washer (14), shaft (15), and pulley (16) from handbrake lever assembly (12).
Working under trailer, pull handbrake cable clevis (17) back through holes in front two braces on trailer
body.
Repeat steps (7) through (9) to remove and disassemble curbside handbrake lever assembly.
WARNING
When lifting trailer body, use lifting equipment with a minimum lifting capacity of 500 lb.
Do not stand under trailer body while it is being lifted. Failure to observe these
precautions can cause injury to personnel or damage to equipment.
Using suitable lifting equipment with a minimum lifting capacity of 500 lb, lift trailer body (4) off of trailer
chassis (5).
b. Repair. Repair of the trailer bed and fenders is limited to replacement of strap fastener loops and
straightening, welding, and repainting the bed and fender weldment. If required, repaint in accordance with
MIL-T-704 and MIL-C-46168. There is one strap fastener loop mounted to the top of each fender. Replace as
follows:
(1) Remove two screws (18), two flat washers (19) and two self-locking nuts (20) securing strap fastener
loop (21) to fender and take off strap fastener loop.
(2) Position new strap fastener loop (21) on fender and secure with two screws (18), two flat washers (19)
and two self-locking nuts (20).
c. Installation.
(1)
(2)
(3)
(4)
(5)
WARNING
When lifting trailer body, use lifting equipment with a minimum lifting capacity of 500 lb.
Do not stand under trailer body while it is being lifted. Failure to observe these
precautions can cause injury to personnel or damage to equipment.
Using suitable lifting equipment with a minimum lifting capacity of 500 lb, lift trailer body (4) onto trailer
chassis (5) and aline mounting holes.
Insert 10 screws (1) with flat washers (2) through trailer bed and through trailer chassis frame rails.
Working under trailer, install one nut (3) on each screw (1).
Insert 16 screws (6) with 16 flat washers (7) through trailer body braces into trailer chassis.
Working under trailer, install one nut (8) on each screw (6). Tighten hardware to secure trailer body to
trailer chassis.
5-5
